Specifications - Sennheiser ew 100 Serie Bedienungsanleitung

ew G3 Set BDAs.book Seite 34 Mittwoch, 30. November 2011 5:52 17

Specifications

Specifications
EM
RF characteristics
Modulation
Frequency range "K"
Receiving frequencies
Switching bandwidth
Nominal/peak deviation
Receiver principle
Sensitivity (with HDX, peak deviation)
Adjacent channel rejection
Intermodulation attenuation
Blocking
Squelch
Pilot tone squelch
Antenna inputs
AF characteristics
Compander system
EQ presets (switchable,
affect the line and monitor outputs):
Preset 1: "Flat"
Preset 2: "Low Cut"
Preset 3: "Low Cut/High Boost"
Preset 4: "High Boost"
S/N ratio (1 mV, peak deviation)
THD
AF output voltage
(at peak deviation, 1 kHz AF)
34
wideband FM
925–932 MHz (see page 4)
280 frequencies, tuneable in steps of 25 kHz
20 fixed frequency banks
EM 100 G3: 1 user-programmable frequency bank
EM 300/500 G3: 6 user-programmable frequency banks
7 MHz
r24 kHz / r48 kHz
true diversity
EM 100 G3: 2,5 xV for 52 dBA
EM 300 G3: 2 xV for 52 dBA
rms S/N
EM 500 G3: 2 xV for 52 dBA
rms S/N
EM 100 G3: t 65 dB
EM 300 G3: t 75 dB
EM 500 G3: t 75 dB
EM 100 G3: t 65 dB
EM 300 G3: t 70 dB
EM 500 G3: t 70 dB
EM 100 G3: t 65 dB
EM 300 G3: t 75 dB
EM 500 G3: t 75 dB
EM 100 G3: Off, Low: 5 dBPV, Middle: 15 dBPV,
High: 25 dBPV
EM 300 G3: Off, 5 to 25 dB PV in 2 dB steps
EM 500 G3: Off, 5 to 25 dB PV in 2 dB steps
can be switched off
2 BNC sockets
Sennheiser HDX
3 dB at 200 Hz
3 dB at 180 Hz
+5.5 dB at 10 kHz
+6 dB at 10 kHz
EM 100 G3: t 110 dB
EM 300 G3: t 115 dB
EM 500 G3: t 115 dB
d 0.9%
¼'' (6.3 mm) jack socket (unbalanced): +12 dBu
XLR socket (balanced): +18 dBu
rms S/N