Sennheiser ew 100 Serie Bedienungsanleitung Seite 165

ew G3 Set 100.book Seite 9 Mittwoch, 30. November 2011 4:52 16
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera's flash mount.
Determine where on the perforated plate
fastened so that the receiver can best be attached to the camera.
At this position, place a square nut
Fasten the flash mount adapter
Lift one side of the belt clip
Press down the belt clip
Repeat for the other side.
Place the perforated plate
Reinsert the belt clip .
Use one of the supplied line cables to connect the line input of the camera to the
socket ³.
³
The shield of the line cable serves as the antenna for the second diversity section.
Putting the devices into operation
the flash mount adapter
under the perforated plate
to the perforated plate
as shown.
at one fixing point and pull it out of the receiver housing.
onto the rear of the receiver.
will need to be
.
using the square nut .
9