Attribute 2, Interface Flags; Attribute 6, Interface Control - TR-Electronic C 58 Serie Benutzerhandbuch

7.8.4.1 Attribute 2, Interface Flags

The Interface Flags attribute contains status and configuration information about
the physical interface and is defined as follows:
Bit Function
0
1
2-4 Negotiation Status
5
6
7-31 Reserved

7.8.4.2 Attribute 6, Interface Control

The Control Bits of Interface Control controls the transfer speed of the
interface.
Bit Function
0
1
2-15 Reserved
The attribute is only active after a restart of the measuring system. The bit 5 of
Attribute 2, Interface Flags indicates that a restart is necessary.
Printed in the Federal Republic of Germany
01/17/2019
Description
0: Indicates an inactive link
Link Status
1:
0: Half Duplex active
Half/Full Duplex
1: Full Duplex active
0: Auto-negotiation in progress
1:
2:
3: Successfully negotiated speed and duplex.
4:
0:
Manual Setting
Requires Reset
1:
0:
Local Hardware
Fault
1: Indicates a local hardware fault is detected
0
Description
0: Auto-negotiation is disabled
Auto-negotiate
1: Auto-negotiation is enabled
0: Half Duplex active
Forced Duplex Mode
1: Full Duplex active
0
TR - ECE - BA - DGB - 0102 - 09
Indicates an active link
see also Bus status display, page 107
Auto-negotiation and speed detection failed. Using
default values for speed and duplex.
Auto negotiation failed but detected speed. Duplex
was defaulted.
Auto-negotiation not attempted. Forced speed and
duplex.
Indicates the interface can activate changes to link
parameters (auto-negotiate, duplex mode, interface
speed) automatically.
Indicates the device requires a Reset service be
issued to its Identity Object in order for the changes
to take effect.
Indicates the interface detects no local hardware
fault
-
-
 TR-Electronic GmbH 2013, All Rights Reserved
Page 165 of 175