Table 22: Electrical Data Across Power Units - Bosch Rexroth PST 6 Serie Betriebsanleitung

1070080029 / 05 | PST 6xx0
Table 22: Electrical data across power units
Power supply
Overvoltage protection
Options for generation of supply voltage for the logic
Power input
Properties of primary voltage (to the AC transformer)
Integrated power sup­
ply unit
(Output: X4 between
terminals 5 and 8)
Power system
Logic (X4)
I/O array
Power system
Nominal current logic
Making current logic
Nominal current fan hood
I/O array
Output voltage
Output current
Electric Drives |
and Controls
400 V -20 % to 600 V +10 %
50 or 60 Hz
Connection to earthed TN or TT mains
Typ. 24 V ; 19 ... 30 V
DC DC
According to I/O module used.
Refer to page 220 et seq.
Metal oxide varistor (MOV)
Via external 24 V power supply unit
DC
Via own supply through the integrated power supply
unit (is fed internally by mains).
Dependent on the integrated power unit.
approx. 1.5 A
(at 24 V ; without fan hood, without I/O module and
DC
without additional consumers at X5)
approx. 2 A for 10 ms
(at 24 V ; without fan hood, without I/O module and
DC
without additional consumers at X5)
approx. 2 A (at 24 V )
DC
According to I/O module used.
Refer to page 220 et seq.
50 Hz; sinusoidal with phase angle
24 V
DC
max. 2 A
" Please note:
When the PST mains supply is switched on, the spe­
cified output current is only available from nominal
mains voltage on, and then only until the PST mains
supply drops to its lower tolerance limit.
Bosch Rexroth AG 311 / 330
Technical data
to EN 61131-2