Technical Data; Safety Precautions; Symbols Used In The Manual - Parkside PLVA 40-Li A1 Originalbetriebsanleitung

GB IE

Technical data

Cordless
Scarifier/Aerator ....... PLVA 40-Li A1
Motor voltage U ...........40 V
Motor current I ................................16 A
Degree of protection ......................... IPX1
Rotating speed of the tool
(n ) ........................... 3600 min
o
Cylinder width ...............................36 cm
Depth adjustment ........................... 5-way
.........(3/6/9/12 mm + transport position)
Volume collection bag ....................... 40 l
Weight (incl. accessories) .. approx. 9,8 kg
Sound power level (L
Guaranteed ......................... 93 dB (A)
Scarifying drum
Acoustic pressure level
(L ) ................ 70.5 dB (A); K
pA
Sound power level (L
Measured . 90.5 dB (A); K
Aerator roller
Acoustic pressure level
(L ) ................ 70.4 dB (A); K
pA
Sound power level (L
Measured . 90.4 dB (A); K
Vibration (a ) ......... 3.3 m/s
n
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
This device can only be operated with
the following rechargeable batteries:
PAP 20 A1, PAP 20 A2, PAP 20 A3.
This type of battery may be charged
with the following chargers: PLG 20 A1,
PLG 20 A3, PDSLG 20 A1.
The noise and vibration values were estab-
lished by the standards and stipulations
listed in the Conformity Declaration.
24
; (2x 20 V)
-1 (r.p.m)
)
WA
= 3 dB
pA
)
WA
= 2.04 dB
WA
= 3 dB
pA
)
WA
= 1.96 dB
WA
; K= 1.7 m/s
2
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at protecting
the user should be based on estimated
exposure under actual usage condi-
tions (all parts of the operating cycle
are to be considered, including, for ex-
ample, times during which the power
tool is turned off and times when the
tool is turned on but is running idle).

Safety precautions

This section covers the basic safety
instructions when working with this
implement.
2

Symbols used in the manual

Warning symbols with
information on damage
and injury prevention.
Hazard symbol with
information on the pre-
vention of personal in-
jury caused by electric
shock.
Instruction symbols with
information on preventing
damage.