Charging Process; Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery - Parkside PLVA 40-Li A1 Originalbetriebsanleitung

Charging Process

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charg-
er, check that the battery's
outer surface is clean and
dry.
There is a risk of injury due
to electric shock.
• Charge the battery before the first time
of use. Do not briefly recharge the bat-
tery several times in a row.
• Only use chargers from the Parkside X
20 V Team series to recharge the bat-
tery.
• If the operating time is considerably
shortened despite charging, this shows
that the rechargeable battery is de-
pleted and must be replaced. Only use
an original replacement battery from
the Parkside X 20 V Team series, which
can be purchased from customer ser-
vice (www.grizzly-service.eu).
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Checking the charge status
of the rechargeable battery
The battery charge status indicator (3)
signalises the state of charge of the bat-
tery (4).
Press the button (2) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (4) when
the red LED on the charge status
indicator (3) is on.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (4) when
the red LED on the charge status
indicator is on.
Charging time is approx. 1 hour.
1. Remove the battery (4) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (4) in the charging
compartment of the battery charger
(5).
3. Plug the battery charger (5) into a
mains outlet.
GB IE
19