Removing/Inserting The Battery; Control Display On Charger; Used Batteries; Storage - Parkside PLVA 40-Li A1 Originalbetriebsanleitung

GB IE
4. When the battery is fully recharged
unplug the battery charger (5) from the
mains.
5. Remove the battery (4) from the charg-
er (5).
Removing/inserting the
Battery
1. To remove the battery (4) from the ap-
pliance, press the release button (1) on
the battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Only insert the rechargeable
battery once the device is
completely assembled. Risk
of injury!

Control display on charger

The direction in which to read the
control display (6) is from the bot-
tom up.
An LED flashes:
Batter(ies) (4) empty
An LED lights up, a second LED flashes:
Batter(ies) charged to 1/3
Two LEDs light up, third LED flashes:
Batter(ies) charged to 2/3
Three LEDs light up:
Batter(ies) fully charged
20

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").

Storage

• Remove the battery before storing the
unit for longer periods of time (e.g.
hibernation).
• Store the battery only in a partially
charged state. The state of charge
should be 40 – 60 % over a longer
storage period (two LED lights on the
charge status display (3) illuminate).
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.
• In order to keep the battery well
charged, avoid exposing the appliance
to extreme heat or cold in storage.
• Store the equipment between 0 °C and
45 °C. During storage, avoid extreme
cold or heat so the battery does not
lose power.