Operation; Stand-By Mode; Switching The Appliance On And Off; Locking/Unlocking - hanseatic HSBS17990WETEI Gebrauchsanleitung

Operation

Before getting started
• Read chapter 'Safety' from page EN-6
and all the safety notices.
• Set up and connect the appliance as
described in chapter 'Start-up' from
page EN-34.

Stand-by mode

If no button is pressed for 30 seconds, all sig-
nals on the control panel will switch off and
the control panel will lock automatically.
To make the indicators light up again,
• push any button.
• open a door.
To unlock the control panel, press and hold
the LOCK/UNLOCK button (22) for 3 sec-
onds until the symbol lights up.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
1. Insert the mains plug into an easily acces-
sible socket (220-240 V~/50 Hz).
– When you open one of the appliance
doors, the interior of the appliance is lit
up.
Operation
– The compressor starts to work, the re-
frigerant flows through the pipes and a
quiet humming sound can be heard. The
appliance is switched on.
2. If the appliance is making unusual noises,
check that it is stable and remove any ob-
jects that may be on top of it.
Switching off
1. Disconnect the mains plug from the sock-
et.
– The signals on the control panel disap-
pear.
– When you open one of the appliance
doors, the lights inside the appliance (5)
remain switched off.
– The compressor is switched off. The ap-
pliance doesn't refrigerate.
2. Empty the appliance and clean it (see
'Care and maintenance' on page EN-28).
3. Leave the appliance doors slightly open
to prevent mould from forming.
Locking/unlocking the control
panel
The fridge-freezer is protected against un-
intentional changes in settings. The
bol lights up on the display. If any button is
pressed, you will hear a beeping sound and
the (23) signal will flash. The control panel
is locked.
The DISPENSER button (25) is not affected
by the lock function.
Page EN-13
(23) (22)
sym-