Maintenance And Care; Regular Maintenance Work; Checking And Renewing The Cutting Blade - AL-KO Solo 4237 Li P Betriebsanleitung

GB
8

MAINTENANCE AND CARE

CAUTION!
Danger of cutting injuries
Danger of lacerations when reaching
into the running mower mechanism.
■
Before all maintenance and care
work: Switch off the appliance and
wait until the mower mechanism has
stopped. Remove the safety key.
■
Wear protective gloves.
8.1

Regular maintenance work

■
Make sure that all nuts, bolts and screws are
tightened and the appliance is in a safe
working condition.
■
Check the grass catcher regularly for correct
operation and wear.
8.2 Cleaning the appliance and mower
mechanism
IMPORTANT!
Danger from water
Water in the appliance causes short-
circuits and destroys electrical
components.
■
Do not spray the appliance with
water.
■
Only use a broom or a brush for
cleaning.
1. Switch off the appliance: Turn the safety key
to 0 and remove it.
2. Remove the rechargeable battery see
chapter 5.2 "Inserting and removing the
rechargeable battery (02)", page 35.
3. Unhook the grass collector.
4. Tip the appliance onto the side and clean the
mower mechanism with a broom or brush.
8.3 Checking and renewing the cutting
blade
■
Check the cutting blade regularly for damage.
Only have blunt or damaged cutting blades
sharpened/replaced by an AL-KO service
centre or authorised specialist company.
■
Resharpened cutting blades must be
balanced. Unbalanced cutting blades cause
strong vibrations and damage the mower.
64
■
Tightening torque of the blade screw 55 Nm
+5.
Help in case of malfunction
8.4 Adjusting the Bowden cable of the
wheel drive (15)
The Bowden cable of the wheel drive lengthens
over time. If the wheel drive can no longer be
switched on with the motor running, the Bowden
cable has become too long and must be
tightened.
CAUTION!
Risk of injury
Sharp-edged and moving appliance
parts (e.g. cutting blade) as well as a
suddenly starting lawnmower can lead
to injuries.
■
Only adjust the Bowden cable when
the motor is switched off and the
mower mechanism has come to a
standstill.
1. Switch off the appliance: Turn the safety key
to 0 and remove it.
2. Turn the adjusting part (15/1) on the Bowden
cable (15/2) in the direction of the arrow, i.e.
anticlockwise until the Bowden cable is taut
between the gear engagement bar (15/3)
and holding point (15/4).
3. To check the Bowden cable setting: Switch
on the appliance, start the motor and try to
switch on the wheel drive.
4. If the wheel drive does not switch on: Repeat
the previous steps.
4237 Li P | 4237 Li SP | 4757 Li SP | 4757 Li VS