Transformer Connection (Primary Circuit); Connection For Programming Terminal - Bosch Rexroth PRC 7000 Betriebsanleitung

272 / 334 Bosch Rexroth AG
Assembly
7.2.3

Transformer connection (primary circuit)

7.2.4

Connection for programming terminal

XFE0 (Ethernet)
XFU0 (USB interface)
The position of the connections is indicated in Section 7.1.1 from
page 251.
" Connect terminal U at the inverter to connection U at the trans­
former.
" Connect terminal V at the inverter to connection V at the transformer.
Additional information on transformer connection (parallel connec­
tion of several transformers, sensors, etc.) is provided in the Instruc­
tions "Rexroth PSG xxxx MF welding transformers" (cf. page 173).
The XFE0 Ethernet connection can be used for networking, refer to
page 202.
The FU0 USB connection is available for connection with
PRC7000.xxx, refer to page 205.
Connection:
Cable length:
PRC7000 |
to USB type A connector
max. 3 m
R911172834 / 02