Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.4 Equipotential bonding
(Fig. 05)
This bonding, required by some regulations,
avoids electric potential differences between
earthed devices installed in the same room. This
appliance has a terminal located under the base
to connect an external conductor, with a ring ter-
minal to insert between two nuts with a nominal
section in compliance with current legislation.
5 - USE OF MACHINE
5.1 Starting the machine and filling
the boiler with water
Open the water shut-off valve.
Bring the lever of the omnipolar power switch to
the "ON" position.
When the switch (Fig. 01; pos. 9) is pressed in the
"ON" position (light
the home page is shown on all the displays
present:
In this machine state, all the machine's functions
are disabled.
By pressing the "press to start" button, the machi-
ne ready page is displayed on each of the groups
present.
on)
Water will be automatically pumped into the
two service boilers if switched on by an external
power switch (Fig. 01; pos. 10). If the machine
is filled with water for more than 120 secon-
ds, the machine goes into an alarm state and
the water stops being pumped into the boiler.
Turn the switch to the "OFF" position (light
off). Repeat the operation by turning the same
switch on and off repeatedly until the pump has
completely filled the boiler and no longer ope-
rates. The groups are, however, in OFF status
and you must access the group setting page to
switch them on
When switched on, the dispenser alarm message
is displayed.
In this stage, the machine dispenses for 15 secon-
ds by activating the pump and solenoid valve of
the selected group in order to fill the coffee boiler.
5.2 Heating
When the service and coffee boilers have been
filled, the heating phase starts. This will stop
when the set temperatures have been reached.
Dispense some water, steam and coffee to en-
sure that the machine has reached the correct
heat balance.
40
BEZZERA VICTORIA
MOD.
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
