Allocating The Connection Cable For The Panel - G&D DLVision-DP Handbuch

The DLV-Power expansion

Allocating the connection cable for the panel

The connection cable, which is provided in the scope of delivery has to be fixed to
the panel. The following figure illustrates how the pins are assigned to the panel's
functions:
1 2 3 4
Figure 1: Pin assignment to the functions of the panel
Figure 2:
To switch one of the ATX-Power or Reset signals, the signal has to be conductively
connected to the shared minus contact (pin 4):
I1 SW1_ATXPWR# (Pin 1)
I2 SW2_RESET# (Pin 3)
- 0V (Pin 4)
Figure 3: Basic circuit with buttons for ATX-Power and Reset
Figure 4:
50 · G&D DL-Vision-DP
I1 SW1_ATXPWR# (Pin 1)
I2 SW2_RESET# (Pin 3)
- 0V (Pin 4)