Installation And Connection - Siemens HF 17526 Gebrauchsanleitung

Installation and connection

q Please observe the special installation instructions.
q This oven is intended for built in use only. It is not
intended for counter top use or for use inside a
cupboard.
q The appliance can be installed in high cabinet
which is 50 or 60 cm wide (at least 30 cm deep
and 85 cm above the floor).
q The appliance is fitted with a plug and must only
be connected to a properly installed earthed
socket. The fuse protection must be rated at
10 amperes (automatic circuit breaker with trigger
characteristic L or B). The mains voltage must
correspond to the voltage specified on the rating
plate.
q The socket must only be installed and the
connecting cable must only be replaced by a
qualified electrician. If the plug is no longer
accessible following installation, an all pole
disconnecting device must be present on the
installation side with a contact gap of at least
3 mm.
q Adapters, multiway strips and extension leads
must not be used. Overloading can result in a risk
of fire.
45