Safety Notes; Storage Of The Operating Instructions; Safe Use; Modifications And Alterations - Stahl 8485 Serie Betriebsanleitung

3 Safety notes

Storage of the operating instructions





Safe use

Before mounting





For mounting and installation











Modifications and alterations

204166 / 848560300010
15.10.2018·BA00·III·en·10
Downloaded from www.Manualslib.com
Read the operating instructions carefully
Store the operating instructions at the mounting location of the device.
Observe applicable documents and operating instructions of the devices to be
connected.
Read and observe the safety notes in these operating instructions!
Ensure that the contents of these operating instructions have been fully understood
by the personnel in charge.
Use the device in accordance with its intended and approved purpose only.
Always consult with R. STAHL Schaltgeräte GmbH if using the device under
operating conditions which are not covered by the technical data.
We cannot be held liable for damage caused by incorrect or unauthorized use of
the device, or for non-compliance with these operating instructions.
Observe national installation regulations (e.g. IEC/EN 60079-14).
Observe national safety and accident prevention regulations.
Before installation and commissioning, make sure that the device is not damaged.
Work on the device (installation, maintenance, overhaul, repair) may only be
carried out by appropriately authorized and trained personnel.
During installation and operation, observe the information (rated operating
conditions) on the rating, data and information plates located on the device.
Always consult with R. STAHL Schaltgeräte GmbH if operating conditions deviate
from the technical data.
Install the devices (8485/1*1-42) in Zones 1, 2, 21, 22 or outside of hazardous
areas.
Connect the device only to equipment, which does not carry voltage higher than
253 V AC (50 Hz).
When loading combustible liquids or gases, make sure that hoses or loading arms
are connected to a tank vehicle only after a proper electrostatic grounding.
Circuits with type of protection "Ex i" operated with circuits with other types of
protection can no longer be operated as circuits with type of protection "Ex i" after
that.
Explosion hazard due to modifications and alterations to the device!
Non-compliance results in severe or fatal injuries.
 Do not modify or alter the device.
No liability or warranty for damage resulting from modifications and
alterations.
manuals search engine
DANGER
Grounding Monitoring Device type 8485
Safety notes
45