Removing A Handset - Topcom BUTLER E400 Gebrauchsanweisung

8.2
This procedure needs to be carried out on a different handset then the one you want to remove.
4 5 6
GHI JKL MNO
8.3
If you want to use a Butler E400 handset with a base of another model. The base must be GAP
compatible.
4 5 6
GHI JKL MNO
4 5 6
GHI JKL MNO
8.4
You can switch your handset between bases. The handsets can be registered up to 4 bases
simultaneously. When selecting the base, the current selected base is indicated by a blinking base
number.
If you select "AUTO" the handset will automatically search for another base when you are out of
range. The handset must first be registered with each base individually.
Downloaded from www.Manualslib.com

Removing a handset

1 Enter the menu
2 Select "SETUP" and confirm.
3 Select "DEL HANDSET" and confirm.
4 Enter the Base PIN code (0000 by default) and confirm.
5 Select the handset to be removed and confirm.
Setting up a handset on another base
1 Put the base in registration mode, refer to the base manual.
2 Enter the menu
3 Select "REGISTER" and confirm.
4 Select "REG BASE" and confirm.
5 Enter the number of the base to be associated with the handset and confirm.
6 Enter the Base PIN code and confirm.
The handset will start searching for the DECT base. If the handset has located
the base, it will display the base identification number.
7 Confirm or stop.
Selecting a base
1 Enter the menu
2 Select "REGISTER" and confirm.
3 Select "SELECT BASE" and confirm.
4 Select a base or select "AUTO" and confirm.
When you have activated Automatic base selection and the handset is out of range
on the current base, the handset will only search for the strongest base in standby
(not during communication).
manuals search engine
Managing multiple handsets
17