Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
29.
Remove Tools 7
30.
Fasten loosely from the top the retaining plate (34) (ATTENTION : Centre-incision against
the top)
31.
Turn Chassis (1) up side down on the top of the centre bolts
32.
Fasten loosely the housing's bottom
33.
Place balance very carefully on the right small side (Chassis has to be downwards) in order
that the Chassis (1) is slipping down inside the housing's bottom
34.
Insert and connect the Main-board and fasten it with the two screws
35.
Fasten with the screws the SCS-Selfcalibration-System (optional) and connect it to the
print. After that centre the retaining plate (34) against the Calibration-System (lift and let down
the SCS-Selfcalibration-System with the MF-Box) and fasten firmly the retaining plate (34)
again
36.
Symmetry fine-adjustment (according to page D 01.09)
37.
Centre Magnetic tube (4) with Tool 8 and fasten firmly the three brass-screws
(ATTENTION : coil-print has to be placed in the centre)
38.
Centre Safety device (21) very carefully (check with the help from a magnify glass for a
concentric space) and after that fasten firmly the screws
39.
Corner-load adjustement (according to page D 01.10/11)
40.
Change DIL-switch no.1 into ON-Position (according to page D 01.12)
41.
Final control (according to page D 01.12)
PAG OERLIKON AG
SERIES-480
ASSEMBLING INSTRUCTIONS
SERVICE - INSTRUCTIONS
D 01.07
Werbung
Inhaltsverzeichnis
