Christopeit Sport RUNNER PRO I loopband Montageanleitung Und Bedienungsanleitung Seite 17

Step 4:
Installation of the computer (49) on the base of computer (50)
with screws M5x10 (61) and washers 5//10 (56).
1. Place on each screw (61) one washer (56) and put them acces-
sibly in front of the foot (2).
2. Place the computer (49) at base of computer (50) and align the
holes in the computer (49) with the holes in the bracket (50).
3. Screw the screws (61) with washers (56) through the holes and
tighten fi rmly.
4. Connect the ends of the computer cable (53) and hand pulse
cables (54)
with the plugs of the computer (49).
5. Place the safety clip (51) in appropriate position onto the com-
puter (49).
Step 5:
Installation of the under prop (52) at bottom frame (2) with the
screws M8x15 (64) and washers 8//16 (59).
1. Place on each screw (64) one washer (59) and put them acces-
sibly in front of the foot (2).
2. Place the under prop (52) against appropriate position in front of
the foot (2) and tight it fi rmly by using the screws (64) with washer
(59).
Step6:
Checks
1. Check the correct installation and function of all screwed and
plug connections.
2. When everything is in order, familiarise yourself with the machine
at a low resistance setting.
Note:
Please keep the tool set and the instructions in a safe place as
these may be required for repairs or spare parts orders becoming
necessary later.
How to move/store your treadmill:
1. Pull the locking knop (15) and place your hand on the end cap
of the system frame then folding the system frame up and lock it
with locking knob.
2. Place your hands on top of the handrails, than lean the machine
toward your body sideways, this way you can move it easily.
17