Assembly Instructions With Exploded Diagrams - Christopeit Sport Cardiff roei Betriebsanleitung

Assembly Instructions
Remove all the separate parts from the packaging, lay them
on the floor and check that all are there on the basis of the
packing list in these instructions for assembly and use. Please
note that a number of parts have been connected directly to
the main frame and preassembled.In addition, there are seve-
ral other individual parts that have been attached to separate
units. This will make it easier and quicker for you to assemble
the equipment.
Step 1:
Attach the front foot (33) at main frame (1).
1. Place the front foot (33) into the holder in front of the main frame
(1) and screw it tightly by using 2 carriage bolts M8x75 (30),
washers (31) and cap nut (32).
Step 2:
Attach the slide rest (18) with seat (13) at seat rail (22).
1. Remove the cushion pads (24) and steel angle (44) from seat rail
(22).
2. Push the slide rest (18) with preassembled seat (13) through the
seat rail (22) as showed in Figure Step 2, so that 4 pulleys can
roll onto the top side and 2 pulleys can roll onto the bottom side
of seat rail (22).
3. Fix the cushion pads (24) at appropriate position on bottom
side of seat rail (22).
4. Put the steel angle (44) at appropriate position of bottom side
of seat rail (22) and tighten with screws (45) firmly to secure the
vertically position of seat rail (22) during fold up position.
Step 3:
Attach the rear foot (29) at seat frame (22).
1. Put the rear foot (29) into the holder at seat frame (22) and
screw it tightly by using screw M8x95 (25), washers (15) and
self locking nut (9). Don't tighten too much that it can move for
fold up.
2. Place the rear foot cover (28) onto the rear foot (29) and secure
by screws (27).
3. Screw in the hand grip screw (2) to secure the rear foot (29) at
seat frame (22).
13