Assembly Instructions With Exploded Diagrams - Christopeit Sport WALKER loopband Montageanleitung

Assembly Instructions
Before beginning assembly, be sure to observe our recommendations
and safety instructions.
Step 1:
Installation of the left support (33) and the right support (24) on the
foot (23) with the screws M8x50 (58), the washers 8//16 (59) and the
cap nuts M8 (61).
1. Place the screws (58), the washers (59) and the nuts (61) accessibly
beside the foot (23).
2. Place the left support (33) on the foot and align so that the hole patterns
in the foot are aligned.
(Note: The transport rollers (21) pre-assembled in the foot (23) must point
backwards (opposite to the line of sight when standing on the machine
during training. Right and left are specifi ed as viewed standing on the ma-
chine during training.)
3. Push on each screw (58) a washer (59) and push them through each
hole.
4. Put a washer (25) on the end of each screw (58) and screw on a nut
(61).
5. Proceed as described in 1. – 4. with the right support (24) on the right
hand side of the foot (23).
Step 2
Installation of cover (38) at main frame (1) and cable (25)
at base of Magnet (18).
1. Put the tension cable (25) into the receiver of the base frame (1) and
insert the end of tension cable (25) into the base of magnet (15). Secure
the position of the tension cable (25) by screwing the nut at the end of the
tension cable in the indicated arrow direction. (See fi gure 1-3)
2. Screw the cover (38) at main frame (1) tightly, by using screws (47) and
washers (62).
Step 3:
Installation of the pre-assembled main frame unit (1) on the left (33)
and right (24) supports with the screws M8x50 (63), the washers 8//22
(64).
1. Place the screws (63), two washers (64) accessibly beside the foot (23).
2. Lay the main frame unit (1) between the supports (33) and (24) and align
so that the hole patterns in the main frame (1) and the supports (33+24)
are aligned. (Note: You should ask a second person to hold the main frame
unit (1) or support it with a suitable object to perform the following steps
of assembly.)
3. Place a washer (64) on each screw (63) and then push the screws
through the holes in the supports (24) and (33) and tighten the main frame
(1) fi rmly.
4. Push the ends of the sensor cable (42) (projecting from the main frame(1))
and sensor wire for support (68) (from the left support (33)) together.
15