Connecting The Fm And Am Antennas; Connecting The Power Cable; Turning This Unit On And Off - Yamaha RX-V2065 Bedienungsanleitung

Connections

Connecting the FM and AM antennas

An indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Indoor FM antenna
(HDMI CONTROL)
PHONO
COMPONENT
VIDEO
OUT
P
R
OPTICAL
DIGITAL
AUDIO
P
B
VIDEO
Y
Ground (GND terminal)
The GND terminal is for noise reduction.
y
• The supplied antennas are normally sensitive enough to obtain good
reception.
• Position the AM loop antenna away from this unit.
• If you cannot get good reception, we recommend that you use an outdoor
antenna. For details, consult the nearest authorized Yamaha dealer or
service center.
• Always use the AM loop antenna even when the outdoor antenna is
connected.
Assembling the AM loop antenna
Connecting the AM loop antenna
The wires of the AM loop antenna have no polarity. You
can connect either wire to the AM terminal and the other
to the GND terminal.
Press and hold
20
En
AM loop
antenna
(BD/DVD)
ANTENNA MONITOR OUT
S VIDEO
COMPONENT
VIDEO
UNBAL.
GND AM
FM
P
R
GND
P VIDEO
B
Y
Insert Release

Connecting the power cable

After all connections are complete, plug the supplied
power cable into the AC inlet and then plug it into an AC
wall outlet.
AC IN
RE
IN
OUT

Turning this unit on and off

1
Press LMAIN ZONE ON/OFF on the front
panel (or pPOWER on the remote control)
to turn on this unit.
2
Press LMAIN ZONE ON/OFF (or
pPOWER) again to turn off this unit
(standby mode).
y
• The unit needs a few seconds until ready to play back.
• You can also turn on this unit by pressing RSCENE (or hSCENE).
• This unit consumes a small amount of electricity even in the standby
mode. We recommend disconnecting the power cable from the AC wall
outlet.
Caution
Do not unplug this unit while it is turned on. Doing so
may damage this unit or cause the settings of this unit
to be saved incorrectly.
To the AC wall outlet