Configuration Programs - Corghi ARTIGLIO UNIFORMITY Betriebsanleitung

of the following criteria, selected by the operator:
- radial run-out
- tread wear
- angle of conicity (if COMPLETE MEASUREMENT programme has been used)
- loaded wheel radius (in all other cases)
To access the IPos TC programme:
- access the wheel selection screen,
- press 'IPos'
- select one of the three criteria available
- fit the wheels as indicated on the screen.

8. CONFIGURATION PROGRAMS

The Configuration programmes are those functions that are intended for customising the
machine's operation and are normally executed when the machine is installed.
To access the configuration programmes, press the INSERT GEARS ICON button and
set-up the following parameters:
- language
- force [N] or [kg] and pressure [bar] or [psi] measurement units
- distance measurement unit [mm] or [inch]
In addition, by connecting a USB keyboard to the corresponding port on the electrical panel
and pressing the key combination Alt+153 it is possible to access the configuration menu
used to customise the minimum and maximum limits for the following measurements:
- the radial run-out of the outer bead housing (1st harmonic)
- the radial run-out of the inner bead housing (1st harmonic)
- the radial run-out of the inner bead housing (peak-to-peak);
- radial force variation (1st harmonic) [N]
- radial force variation (peak-to-peak) [N]
- radial force variation (2nd harmonic) [N]
- radial run-out of wheel (1st harmonic) [mm]
- lateral force variation (1st harmonic) [N]
- lateral force variation (peak-to-peak) [N]
- plysteer [N]
- taper [°]
- tread depth [mm]
164
,
,
,
.
Artiglio Uniformity User Manual
,