Utility And Configuration Programmes - Corghi EM9780 plus AutomaticLine Betriebsanleitung

correspondence of the wheel dimensions from
the last spin.
- perform a spin;
- Place the clip weight in the 12 o'clock position.
Motorcycle ALU Programme
Proceed as follows to balance motorcycle wheels
dynamically using adhesive weights:
- follow the instructions for mounting the motor-
cycle adapter described in the MOTORCYCLE
DYNAMIC PROGRAMME.
- Select the MOTO environment using the
icon located in the secondary
control keypad.
- Select the ALU 3 balancing programme directly
from the touch screen monitor;
Now the corresponding balancing planes are
displayed on the rim on the screen.
Proceed as described previously for the "Motor-
cycle Dynamic" programme.
- place the adhesive weight in the 12 o'clock
position.
Best results can be achieved if the adhesive
weights are positioned with the outer edge being
flush with the rim edge.
Split Weight Programme
Some rims have spokes so wide that it is not pos-
sible to place adhesive weights next to them; a
program which divides the counterweights into two
parts has been introduced to solve this problem.
In this case, when the centred position is reached
and it becomes obvious that the balancing weight
will have to be applied in line with a spoke, pro-
ceed as follows:
- Remain in the centred position.
- the machine will display the split weight
button on the main working
screen;
- press the
alternatively displays the possible spoke
dimensions: small
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
button in sequence
, medium
, large
(selection disabled);
- simultaneously, after selecting the spoke
type the machine will display the two new
counterweights to be applied;
- apply two new counterweights in the positions
indicated at 12 o'clock.
The weight division operations can be performed
on both balancing sides.
UTILITY AND
CONFIGURATION
PROGRAMMES
The Utility programmes are all the functions of
the machine that are useful for its operation but
are not strictly connected to its normal operation.
To display the list of Utility programmes, select
the Utility and Configuration programmes icon.
The programmes in this sub-menu are now
available:
1.
SPIN COUNTER
2.
SET MANUAL WHEEL DIMENSIONS
3.
W H E E L D I A G N O S I S
4.
UNBALANCE OPTIMISATION PROGRAMME
or OFF
UK
P R O G R A M M E
73