Yamaha RX-V620RDS Bedienungsanleitung Seite 67

Problem
The volume level The component connected to the REC OUT
cannot be increased,
jacks of this unit is turned off.
or the sound is
distorted.
The effect and It is not possible to record the effect and
surround sounds
surround sounds by a recording component.
cannot be recorded.
A source cannot be
A source component is only connected to the
recorded by a digital
analog input jacks of this unit.
recording component
connected to the
DIGITAL OUTPUT jack
of this unit.
The sound field "10 MEMORY GUARD" on the SET MENU
parameters and some is set to ON.
other settings on this
unit cannot be
changed.
When TUNER is
The OSD mode is set to short display or
selected, the DSP
display off.
program name shown
on the display
immediately changes
to the frequency.
This unit does not
The internal microcomputer has been frozen
operate properly. by an external electric shock (such as
lightning or excessive static electricity) or by
a power supply with low voltage.
The sound is degraded
This unit is in the standby mode.
when listening with
headphones
connected to a tape
deck or CD player that
is connected to this
unit.
There is noise
The unit is too close to the digital or high-
interference from frequency equipment.
digital or high-
frequency equipment,
or the unit.
Cause
Turn on the power to the component.
Connect the source component to the digital
input jacks of this unit.
Select OFF.
If you want the DSP program name display
to be shown constantly, set the OSD mode to
full display.
Disconnect the AC power cord from the
outlet and then plug it in again after about
30 seconds.
Turn on the power of the unit.
Move the unit further away from such
equipment.
TROUBLESHOOTING
Remedy
Refer to
page
12
38
12 – 15
45
20
—
—
—
65