Safety Regulations - SICE M 39 ATV Betriebsanleitung

ENGLISH • Instructions manual
• a dedicated power plug in compliance with the relevant electrical safety standards.
• a suitable circuit-breaker (residual current set to 30 mA) on the mains connection.
• power line fuses in accordance with specifications in the main wiring diagram of this manual.
• a suitable earthing system installed on the workshop mains lane.
- To prevent unauthorised use of the machine, always disconnect the mains plug when the machine is not used (switched off)
for extended periods time.
- If the machine is connected directly to the power supply by means of the main electrical panel and without the use of a plug,
install a key-operated switch or suitable lock-out device to restrict machine use exclusively to qualified personnel.
WARNING
For correct and safe operation of the machine it must be connected to an efficient grounding circuit.
NEVER connect the ground wire to a gas pipe, water pipe, telephone line or other makeshift system.
WARNING
ONLY FOR THREE-PHASE VERSION
Check the motor rotation .
If the motor rotates in the direction shown by the arrow attached.
If not, it is necessary to have two phase cables on the three-phase plug inverted from each other, by specialised personnel.
For correct operation of the machine the compressed air supply line must provide a pressure range from a minimum of 8 bar to
a maximum of 16 bar.
- Hook-up the compressed air using the coupling provided in the machine kit
- Before the control box access, mount an airconditioning group with condensate seperator, lubricator and a pressure reducer
valve that will filter, dry and lubricate and reduce the pressure to the working pressure required as indicated in the TECHNICAL
DETAILS paragraph.
The equipment is intended for professional use only.
WARNING
Only one operator may work on the equipment at a time.
WARNING
Failure to observe these instructions and the relative danger warnings can cause serious injury to the operator and
others. Do not power up the machine before you have read and understood all the danger/warning/attention notices in
this manual.
This machine must be used only by qualified and authorised personnel. A qualified operator is construed as a person who has
read and understood the manufacturer's instructions, is suitably trained, and is conversant with safety and adjustment procedures
to be adhered to during operations. Operators are expressly forbidden from using the machine under the influence of alcohol or
drugs capable of affecting physical and mental capacity.
The following conditions are essential:
- The operator must be able to read and understand all the information in this manual.
- Make sure you have a thorough knowledge of the capabilities and characteristics of this machine.
- Keep unauthorised persons well clear of the area of operations.
- Make sure that the machine has been installed in compliance with established legislation and standards.
- Make sure that all machine operators are suitable trained, that they are capable of using the machine correctly and that they
are adequately supervised during their work.
- Never leave nuts, bolts, tools or other equipment on the machine to avoid the risk that they could become entrapped between
moving parts during work.
- Do not touch power lines or the inside of electric motors or other electrical equipment until the power has been disconnected
and locked out.
- Read this manual carefully and learn how to use the machine correctly and safely.
- Always keep this user manual in a place where it can be readily consulted when working with the machine and consult it
whenever you are in need of confirmation or explanations.

SAFETY REGULATIONS

25
M 39 ATV