Herunterladen Inhalt Inhalt Diese Seite drucken

Filling The Water Tank - Gastroback Design Espresso Advanced Barista Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Design Espresso Advanced Barista:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

IMPORTANT - Before each use of the machine, check the filling level in the water
tank. We recommend to change the water at least every day. For operation, only
fill clear tap water or low-mineral, non-carbonated table water into the water tank.
Do NOT use high-mineral water or distilled or highly filtered water, as this will
affect the taste of your coffee and the functioning of your machine unfavourably
(see: 'Tips for Best Results / The Water Quality').
IMPORTANT - Descale the appliance in time to avoid damage and high energy
loss due to excessive deposits of lime (see: 'Care and Cleaning / Descaling the
Appliance'). The water hardness and usage are crucial for the frequency of desca-
ling. As a rule of thumb, descale the water system after 6-20 litres flowed through,
or at the latest, when the descaling indicator illuminates.
IMPORTANT - If the appliance has not been used for more than a week,, we
recommend to flush the water system before using the appliance again (see:
'Before First Use / Flushing the Water System').

FILLING THE WATER TANK

CAUTION
– Do not tilt the water tank or attempt to push it sidewise, when
removing or installing the water tank, to avoid damage to the valves at the bottom
of the water tank or at the water intake of the appliance. Always move the water
tank vertically for removing or installing the water tank.
NOTE
When the water tank sticks stubbornly within the machine, it may be easier to
remove the water tank by holding it at both sides.
1. Grasp the water tank lid at the rear of the appliance und pull it upwards. There-
after you can fold the water tank lid back for filling the water tank. However, it
is better to pull out the water tank from the rear of the machine. For this, grasp
the water tank lid and pull it vertically upwards.
2. Fill the water tank up to the MAX filling level with clear, cold drinking water (tap
water or low-mineral, non-caronated table water). Do not use mineral water,
de-mineralised water, or highly filtered water. Ensure that the exterior of the
water tank is completely dry.
3. At the rear of the appliance, slide the water tank vertically down. Close the
water tank lid by pushing it down carefully, When the water tank is installed
correctly, the water tank lid levels up with the top of the appliance. If required,
gently press down the water tank.
EN
107

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis