Measuring Functions - Bosch 80+R60 Originalbetriebsanleitung

OBJ_BUCH-1347-001.book Page 28 Friday, January 21, 2011 10:30 AM
28 | English
Basic Settings
Display rotation
Permanent laser
beam
Unit of measure,
distance (depending
on country version)
Unit of measure,
angle
With exception of the "Permanent laser beam"
setting, all basic settings are retained when
switching off.
Continuous Laser Beam
Do not point the laser beam at persons or
animals and do not look into the laser beam
yourself, not even from a large distance.
In this setting, the laser beam also remains
switched on between measurements; for meas-
uring, it is only required to press the measuring
button 2 once.

Measuring Functions

Simple Length Measurement
For length measurements, press button 12 until
the "length measurement" indication
on the display.
To switch the laser on and for
measuring, briefly press the
measuring button 2 once each
time.
The measured value is displayed
in the result line c.
For several subsequent length measurements,
the last measured results are displayed in the
measured-value lines a.
2 609 140 807 | (21.1.11)
Area Measurement
For area/surface measurements, press button
12 until the indicator for area measurement
On
appears on the display.
Afterwards, measure the length and the width,
one after another, in the same manner as a
Off
length measurement. The laser beam remains
switched on between both measurements.
On
Off
m, ft, inch, ...
Volume Measurement
°, %, mm/m
For volume measurements, press button 12 un-
til the indicator for volume measurement
pears on the display.
Afterwards, measure the length, width and the
height, one after another, in the same manner as
for a length measurement. The laser beam re-
mains switched on between all three measure-
ments.
Values above 999999 m
"ERROR" appears on the display. Divide the vol-
ume to be measured into individual measure-
ments; their values can then be calculated sepa-
appears
rately and then summarized.
Continuous Measurement (Tracking) / Mini-
mum/Maximum Measurement (see figure B)
For continuous measurements, the measuring
tool can be moved relative to the target, where-
by the measuring value is updated approx. every
0.5 seconds. In this manner, as an example, you
can move a certain distance away from a wall,
while the actual distance can always be read.
Upon completion of the second
measurement, the surface is au-
tomatically calculated and dis-
played in the result line c. The in-
dividual measured values are
displayed in the measured-value
lines a.
Upon completion of the third
measurement, the volume is au-
tomatically calculated and dis-
played in the result line c. The in-
dividual measured values are
displayed in the measured-value
lines a.
3
cannot be indicated;
Bosch Power Tools
ap-