Working Advice - Bosch 80+R60 Originalbetriebsanleitung

OBJ_BUCH-1347-001.book Page 31 Friday, January 21, 2011 10:30 AM
List of the last Measuring Values
The measuring tool stores the last 20 measuring
values and their calculations, and displays them
in reverse order (last measured value first).
To recall the stored measure-
ments, press button 7. The re-
sult of the last measurement is
indicated on the display, along
with the indicator for the meas-
ured-value list e and the memory
location of the displayed measurements.
When no further measurements are stored after
pressing button 7 again, the measuring tool
switches back to the last measuring function. To
exit the measured-value list, press one of the
measuring-mode buttons.
To continuously save the currently displayed
length measurement value as a constant, press
and hold the measured-value list button 7 until
"CST" is indicated on the display. A measured-
value list entry cannot be subsequently saved as
a constant.
To use a length measurement value in a measur-
ing mode (e. g. area/surface measurement),
press the measured-value list button 7, select
the desired entry and confirm by pressing the
result button 6.
Deleting Measured Values
Briefly pressing button 8 deletes the last individ-
ual measuring value determined in all measuring
functions. Briefly pressing the button repeated-
ly deletes the individual measured values in re-
verse order.
To delete the currently displayed measured-val-
ue list entry, briefly press button 8. To delete
the complete measured-value list and the con-
stant "CST", press and hold the measured-value
list button 7 and at the same time briefly press
button 8.
In wall surface measurement mode, briefly
pressing button 8 the first time deletes the last
individually measured value; pressing the button
a second time deletes all lengths B
ing the button a third time deletes all room
heights A.
Bosch Power Tools
Adding Measured Values
To add measured values, firstly carry out any
measurement or select an entry from the meas-
ured-value list. Then press the plus button 11.
For confirmation, "+" appears on the display.
Then carry out a second measurement or select
another entry from the measured-value list.
After calculation of the sum, further measured
values or measured-value list entries can be add-
ed to this result when pressing the plus button
11 prior to each measurement. Pressing the re-
sult button 6 ends the addition.
Notes on the addition:
– Mixed length, area and volume values cannot
be added together. For example, when a
length and area value are added, "ERROR"
briefly appears on the display after pressing
the result button 6. Afterwards, the measur-
ing tool switches back to the last active
measuring mode.
– For each calculation, the result of one meas-
urement is added (e.g. the volume value); for
continuous measurements, this would be the
displayed measured value in result line c. The
addition of individual measured values from
the measured-value lines a is not possible.
Subtracting Measured Values

Working Advice

General Information
, and press-
X The reception lens 17 and the laser beam outlet
16 must not be covered when taking a measure-
ment.
English | 31
To call up the sum of both meas-
urements, press the result but-
ton 6. The calculation is indicat-
ed in the measured-value lines a,
and the sum in the result line c.
To subtract measuring values,
press minus button 5; For confir-
mation, "–" is indicated on the
display. The further procedure is
analog to "Adding Measured Val-
ues".
2 609 140 807 | (21.1.11)