Storing The Power Cord And Hoses; Storing The Controller - Stryker Altrix Handbuch

Storing the power cord and hoses

After you complete therapy or when you transport the product, store the power cord and hoses.
CAUTION
• Do not hang items on the controller handle to avoid the risk of tipping the product.
• Always store the power cord, cables, and hoses before you transport the product to reduce the risk of trip hazard.
To store the power cord and hoses:
1. Connect the ends of the connector hoses together, if applicable.
2. Coil and fasten the hose with the management straps
3. Unplug the power cord from the wall outlet and store with the management straps

Storing the controller

Storage is equal to or greater than 7 days without use.
CAUTION
• Do not store the product with water in the device.
• Always store the product within the specified environmental condition values.
To store the controller:
1. See Disinfect the internal water circuit and hoses every 14 days on page
2. See Draining the thermal transfer devices on page
3. See Cleaning the external surfaces on page
4. See Disinfecting external surfaces on page
Notes
• Always bring the controller to room temperature after high or low temperature storage.
• Always store the controller with the reservoir in place.
www.stryker.com
Operation
(Figure 1-23 on page
Figure 1-23: Management straps
1-35.
1-39.
1-40.
8001-109-005 REV B
1-37).
(Figure 1-23 on page
1-41.
English
EN
1-37).
1-37