Tare Weighing - Soehnle Professional 9320 Bedienungsanleitung

On/Off switch
bottom left
9320
9320
9320
9320
9320
9320
9320
9320
9320
9320
Power-on
Only when the scale is not loaded.
After the test routine, the display is set to zero.
The scale is ready for use.
Place the weighing product on the scale.
The display shows the gross weight.
The measured values stabilise after a short warm-up peri-
od of 15 minutes after power-on. Place the weighing pro-
duct carefully on the scale. Do not keep any loads perma-
nently on the platform.
Avoid shocks and loading the scale beyond specified
maximum load.
These could damage the scale.
Setting the backlighting mode
Press the key.
The function toggles between the operating states > Off >
Active in weighing mode > Continuous mode.
If the backlight is continuous mode, the scales only
approx. 30% of the possible battery service time.
Zero
If zero is not indicated when the scale is unloaded, press
the key.
Possible zero range -2 % ... +2 % of the weighing range.

Tare weighing

Place a container on the platform and press the
key.
The display is reset to zero and Net is displayed.
Place the weighing product on the scale. After the display
settles, the net weight of the weighing product is display-
ed.
Clear tare: when the scale is empty, press the
Totalising
Weight values > min. area or piece number can be stored
in the total memory by pressing the
totalising operations are possible, but only up to a six-digit
value. The M+ symbol is displayed after the first totalising
operation. To perform further totalising operations, empty
the scale, place the next weight on the scale and press
the key again. Press
number of totalising operations appears first, followed by
the value.
Clear total: press the
ENGLISH
key. Max. 9999
to display the total. The
and keys one after another.
key.
13