Adjustment Of Wind Direction - Toshiba RAV-SM408CTP-E Bedienungsanleitung

6

Adjustment of wind direction

For best cooling and heating performance, adjust the
louvers (adjustment plates of up / down wind direction)
appropriately. Cold air descends and warm air rises, so
to heat a room tilt the louvers downward, and to cool a
room tilt them horizontally.
CAUTION
Direct the louvers horizontally for cooling.
If the louvers stay pointed downward during cooling,
condensation may form on the discharge port and / then
drops from the louvers.
When operation is stopped, the horizontal louver
(plate for adjusting the vertical air flow) automatically
closes.
In heating preparation mode, the horizontal louver
(plate for adjusting the vertical air flow) points
upward. The louver starts swinging when the heating
preparation mode has finished, but the swing
indicator appears on the remote controller even in
heating preparation mode.
As characteristics of air, cold air
accumulates lower area and warm air
accumulates upper area.
91-EN
1114653801_EN.indb 46 1114653801_EN.indb 46
1
Unit select
button
How to set up the wind direction
1
Push during operation.
The wind direction changes for every push of the
button.
In Heat operation
Direct the louver (adjustment plate of up / down wind
direction) downward. If directing at horizontally, hot air
may not come to the foot.
Initial setup
In Cool / Dry operation
Direct the louver (adjustment plate of up / down wind
direction) horizontally. If directing it downward, the dew
may form on the surface of the air discharge port and
may drop down.
Initial setup
In Fan operation
Select a desired wind direction.
Initial setup
How to start swinging
1
Push , set the louver (adjustment plate
of up / down wind direction) direction to the
lowest position, and then push
SWING is displayed and the up / down wind
direction is automatically selected.
Display during swinging
Repeat
How to stop swinging
1
Push at a desired position while the
louver is swinging.
When is pushed after that, wind direction
can be set again from the highest position.
* However, even if is pushed while the louver
is swinging, the louver position is displayed as
follows and highest position of the louver may not
be selected.
Display when swinging is stopped
Fan / Heat Cool / Dry
operation operation
In this case, push again two seconds later.
In Cool / Dry operation, the louver does not stop
as it directs downward. If stopping the louver as
it directs downward during swing operation, it
stops after moving to the third position from the
highest position.
Display when stopping the swing
Fan / Heat Cool / Dry
operation operation
– 46 –
Unit select button
When multiple indoor units are controlled with one
remote controller, wind direction can be set for each
indoor unit by selecting individually.
again.
To set wind direction individually, push
button (left side of the button) to display an indoor
unit number in the control group. Then set the wind
direction of the displayed indoor unit.
When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
Each time button (left side of the button) is
pushed, the display changes as follows:
Unit No. Unit No. Unit No.
1-1 1-2 1-3
Not Unit No.
display 1-4
Horizontal air flow adjustment
To change the horizontal air flow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
NOTE
When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
When the horizontal louver is pointing horizontally in
HEAT mode, the air may not warm up the room
evenly.
EN
EN
ID
92-EN
10/4/16 1:46 PM 10/4/16 1:46 PM