Adjustment Of Wind Directiond - Toshiba RAV-SM560UT-E Betriebsanleitung

ADJUSTMENT OF WIND DIRECTIONd

• When the air conditioner stops, the flap (adjustment plate of up/down wind direction) directs downward
automatically.
• When the heating operation is in READY states, the flap (adjustment plate of up/down wind direction) directs
upward. The swinging starts after HEAT READY status cleared, SWING
controller even if the heating operation is in READY status.
How to set up the wind direction
1
Push during operation.
The wind direction changes for every push of the button.
In HEAT operation
Direct the flap (adjustment plate of up/down wind direction) downward. If directing
at upward, hot air may not come to the foot.
In COOL/DRY operation
Direct the flap (adjustment plate of up/down wind direction) upward. If directing it
downward, the dew may from on the surface of the air discharge port and may
drop down.
How to start swinging
1
Push , set the flap (adjustment
plate of up/down wind direction) direction
to the lowest position, and then push
again.
SWING is displayed and the up/down wind
direction is automatically selected.
How to stop swinging
1
Push SWING/WIND again while the flap is
swinging.
• The flap stops at a position when you push.
After then, if pushing
direction descends from the highest position.
• In COOL/DRY operation, the flap does not
stop as it directs downward. If stopping the
flap as it directs downward during swing
operation, it stops after moving to the 3
position from the highest position.
, the wind
rd
8
is displayed on the remote
SET CL
In FAN operation
Initial setup
Display when stopping the swing
Fan/Heat
operation
Initial setup
Initial setup
UNIT
In all modes
Series of
operation
Cool/Dry
operation