Invacare Personal Back Anbau, Installations-Bedienungsanleitung Seite 3

6. Repeat STEPS 1 - 4 for remaining half-clamps, en-
suring that both sides are matched for height, and are
parallel to each other.
7. Install Personal Back. Refer to PERSONAL BACK/
PERSONAL BACK PLUS INSTALLATION in this in-
struction sheet.
FRONT OF
WHEELCHAIR
Insert
Clamp
DETAIL "A"
BACK OF
Clamp
WHEELCHAIR
Slide Clamp
OVER Insert
Back Cane
Insert
SIDE VIEW
FIGURE 3 - INSTALLATION ON WHEELCHAIRS
WITH 7/8-INCH (22MM) DIAMETER BACK
CANES
Installation on Wheelchairs Using L-Shaped
Brackets (FIGURE 4)
Have the following tools available:
Phillips Head Screwdriver
3/8-inch Crescent/Box Wrench
Parts Required:
Multi-Position Plate
L-Brackets
Short Phillips Head Bolts
Locknuts
1. Determine back height. Refer to DETERMINING THE
MOUNTING POSITION FOR INSTALLATION OF
PERSONAL BACK in this instruction sheet.
Back Cane
BACK OF
WHEELCHAIR
BACK OF
WHEELCHAIR
Clamp
Back
Cane
Insert
TOP VIEW
Quantity
2
2
4
4
3
2. Secure the L-shaped brackets to the back canes us-
ing existing upholstery holes and existing hardware.
3. Ensure that the top of the mounting plate when in-
stalled to the L-shaped bracket is 1/2-inch (1.2 cm)
higher than the mark determined in STEP 8 of DE-
TERMINING THE MOUNTING POSITION FOR IN-
STALLATION OF PERSONAL BACK in this instruc-
tion sheet (DETAIL "A", FIGURE 4).
4. Install two (2) short bolts (from the inside) through the
small holes on mouting plate, then through L-shaped
braket. Tighten down locknuts to secure mounting
plate to L-shaped bracket.
5. Repeat the procedure for the other side, ensuring that
both side are matched for height, and are parallel to
each other.
6. Install Personal Back. Refer to PERSONAL BACK/
PERSONAL BACK PLUS INSTALLATION in this in-
struction sheet.
Inside
Mounting
Plate
Short Bolt
Existing
Hardware
DETAIL "A"
FIGURE 4 - INSTALLATION ON WHEELCHAIRS
USING L-SHAPED BRACKETS
Existing
Upholstery
Mounting Hole
L-Bracket
Outside
Locknut
1/2-inch
Mark
USA/UK ENGLISH