Inhaltsverzeichnis
Werbung
Projector Adjustment and Connecting
3-3. Turning your Projector On
• Do not use the projector with the lens cap left attached, and do not attach the lens cap while the projector is operat-
NOTE
ing. The lens cap may become hot, causing them to deform or melt.
• In the following instances, the power to your projector cannot be turned on even if you press the POWER button.
- When the inside temperature is abnormally high. The protective function prevents power from turning on. Wait
some time (until the projector inside cools down) and then turn on the power.
- When the rear status indicator is blinking red without the lamp lighting up after power-on. Your projector may be
in trouble. Check the error display on the LCD screen and contact your dealer/distributor for instructions.
Preparation:
• Connect the power cable to the projector (See Projector User's Manual).
• Supply AC power to the projector.
1
Remove the lens cap.
2
Check that the VOLTAGE SELECT switch is set to match the voltage of the power supply you
are using.
CAUTION:
You should select a power cable which is appropriate for the voltage of the electrical outlet you are connecting the projector to,
and set the VOLTAGE SELECT switch properly. If the selection or setting is wrong, it may cause fires, or damage to the
projector.
Voltage of power to use
AC100V-130V outlet
AC200V-240V (single phase)
outlet
3
Turn on the main power switch on the side of the projector.
The light source is turned off, the POWER indicator blinks green, and the rear status indicator blinks orange (cooling state).
The fan will continue to rotate while cooling, and the amount of time remaining for cooling is displayed on the LCD screen.
KEY LOCK becomes automatically on if no control panel operation takes place in the standby state for 30 seconds by
default. Buttons on the control panel do not function while KEY LOCK is on.
4
If KEY LOCK is on, press the KEY LOCK button for one second or longer.
KEY LOCK becomes off. The KEY LOCK button indicator turns off and buttons on the control panel become operable.
52
Position of the VOLTAGE SELECT switch
"100 130V–"
"200 240V–"
Werbung
Inhaltsverzeichnis
