Inhaltsverzeichnis
Werbung
3-2. Turning your projector on
The power to this projector is separated to the power to the projector head and power to the lamp. To project an image, it is
necessary for both power supplies to be on.
Preparation:
Supply AC power to the projector head and to the lamp power supply unit.
Please contact your dealer/distributor to connect the power cord.
NOTE
• Turn off the main power switch to the projector head and the lamp power supply unit when supplying or
cutting AC power to the projector and the lamp power supply unit.
If power is supplied or cut while the main power switch is turned on, the projector will be damaged.
• Be sure to turn your projector on or off in two steps of operation with the "main power switch" and the
"POWER button" ("POWER ON/OFF button" on the remote control).
• Turning power on (See this page)
[1] Turn the "main power switch" on the lamp power supply unit and the projector head to on.
Your projector is set in a standby state.
[2] Press the POWER button (POWER ON button on the remote control) three seconds or longer.
Your projector is turn on.
• Turning power off (See page 24)
[1] Press the POWER button (POWER OFF button on the remote control) three seconds or longer.
Your projector is set in a standby state.
[2] When the fan has stopped running, set the "main power switch" on the lamp power supply unit and the
projector head to OFF.
Your projector is turned off.
1
Remove the lens cap.
2
Turn the main power switch on the lamp power supply unit to on.
The lamp power unit fan will begin rotating.
ON
3
Turn the main power switch on the side of your projector head to on.
A buzzer will ring on the projector. The POWER indicator and rear STATUS indicator light up orange (standby state).
3. Projection of Images (Basic Operation)
19
Werbung
Inhaltsverzeichnis
