Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
VIVO-D203(M)
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
IMPORTANT
other explanations which must be taken into account. The installation manual can be downloaded by going
NOTE
to the "Downloads" section of Erreka website:
http://www.erreka-automation.com
NOTE: this control panel is valid
for operators for the following
types of door and gate:
swing (C301),
sliding (C302),
up-and-over (C303).
Electrical wiring
A: Main power supply
B/F: Flashing light with antenna
C: Photocells (Rx / Tx)
D: Key switch
E: Operator
VERY IMPORTANT: the TC closing stopper and the TA
opening stoppers must be installed.
Power supply and peripheral connections (valid for all cases)
EPS1: card for traffic lights
(with parameter Ab00). See
other options on page 24
(parameters Ab02 and Ab03).
ST1: open
ST2: close
DL6: LED ST1
DL8: LED ST2
DL13: LED radio running
DL14: LED battery
DL15: LED 12Vdc
DL16: LED mains
Elements of the complete installation
TA
DL13
EPS1
DL14
FT
ST1
ENCODER1
ENCODER2
-FT
ST2
(Test)
P13 P14 P15 P16 P17 P18 P19 P20
P21 P22 P23
DL6
DL8
P1 P2 P3
P4 P5 P6
P7 P8
TC
TA
DL15
F3
CN22
+24Vdc
P24 P25
MOTOR2
AUX
G4 G5 G6
24 Vdc
MOTOR1
P9 P10
P11 P12
G7 G8
G1 G2 G3
(12Vdc)
F2
DL16
F1
VIVO-D203:
VIVO-D203M:
G9 G10
N
L
POWER - 230V
VIVO-D203:
VIVO-D203M:
VIVO-D203:
230Vac, max 2.300W
VIVO-D203M:
125Vac, max 1.250W
English
E255A
CHG
LB/ LR
(resistive)
(resistive)
P255Z
17
Werbung
Inhaltsverzeichnis
