The opening and closing stopper must be installed before programming the travel (see the
operator manual).
8
Start opening of leaf 1
with ST1:
8a
With up-and-over door
and slowdown, press
ST1 again to pass from
slow to quick speed.
11
Start opening of leaf 2
with ST1:
14
Start closing of leaf 2
with ST1:
17
Start closing of leaf 1
with ST1:
17a
With up-and-over door
and slowdown, press
ST1 again to pass from
slow to quick speed.
20
U255O
22
Travel programming (all cases)
The door/gate carries
6
o u t t h e a p p r o a c h
manoeuvre (closes in
order to save the closing
point).
9
Start slowdown of leaf 1
with ST1
( o n l y w i t h C A 0 1 o r
CA02):
U255G
12
Start slowdown of leaf 2
with ST1
(only with CA01 or CA02):
U141K
15
Start slowdown of leaf 2
with ST1
(only with CA01 or CA03):
U141N
18
Start slowdown of leaf 1
with ST1
( o n l y w i t h C A 0 1 o r
CA03):
U255T
21
10
Finish opening of leaf 1 with ST1:
In any case, this is carried
out automatically when
the
opening
(with C700, C701, C703
or C704) or the FCA
(with C702 or C704) is
reached.
U141I
13
Finish opening of leaf 2 with ST1:
In any case, this is carried
out automatically when
the
opening
(with C700, C701, C703
or C704) or the FCA
(with C702 or C704) is
U141L
reached.
16
Finish closing of leaf 2 with ST1:
In any case, this is carried
out automatically when
the closing stopper (with
C700, C701, C703 or
C704) or the FCC (with
C702
reached.
U241R
19
Finish closing of leaf 1 with ST1:
In any case, this is carried
out automatically when
the closing stopper (with
C700, C701, C703 or
C704) or the FCC (with
C702
reached.
U241U
The anti-trapping safety system continues to run during
the programming operations.
Pedestrian opening is programmed using F3, meaning the
travel for this pedestrian opening does not need to be
programmed.
If an obstacle is detected during programming in up-
and-over
activated, this will be considered the point from which
the photocell shadow function should be activated.
This only works with Collective Opening (A901).
U141P
The procedure with a
swing
below.
Proceed
manner for sliding gates
or up-and-over doors.
stopper
stopper
or
C704)
is
C704)
or
is
operation
with
C5
gate
is
shown
in
the
same
U241J
U241M
U241S
U241V
Closing
photocell