Christie LX1750 Netzwerkinstallation Und Betrieb Seite 34

About projector condition
Status
Normal ............................................................... Projector is operating normally.
Power management in operation ........... Power management is operating.
Shutter management in operation ...... Shutter management is operating.
Lamp failure ................................................... Lamp failure is occurring.
Abnormal temperature ......................... The temperature of the projector became too high.
Standby after Abnormal Temp. ........ Projector detects abnormal temp. and sets into standby mode.
Power failure ................................................ Power failure has occurred inside the projector. Projector is turned
When a security (PIN code lock) has been set on the projector, you also cannot
control it through the network. To control the projector through the network
temporarily, execute "PJ lock suspend" command to unlock the security. "PJ lock
suspend" is on setting sub menu [3] on Setting main menu. (+p.41)
LX1750 Network User Manual
020-000639-01 Rev.1 (11-2013)
Description
off. Unplug the AC cord and ask servicing to a qualified service
personnel.
Power control and status check
33