Assembly - Parkside PNTS 1500 D5 Originalbetriebsanleitung

To avoid accidents and injuries from
electric shocks:
• Ensure that the mains cable is
not damaged by being pulled
over sharp edges, by jamming,
or by pulling on the cable.
• Before each use, check the pow-
er supply lead and the extension
cable for damage and ageing.
Do not use the equipment if the
cable is damaged or worn. Dan-
ger of electric shock hazard.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.
• Switch the machine off and dis-
connect the mains plug:
- when the machine is not in use,
- before the machine is opened
up,
- for all maintenance and clean-
ing work,
- if the connecting cable is dam-
aged or tangled up.
• Never use the mains lead to pull
the plug out of the socket or to pull
the appliance. Protect the cable
from heat, oil, and sharp edges.
• Make sure that the mains volt-
age corresponds with the infor-
mation on the rating plate.
• Only plug the appliance into a
socket which is safeguarded.
• The device must only be con-
nected to a mains socket via a
residual-current circuit breaker
(RCD) with a rated leakage cur-
rent of not more than 30 mA.
• Do not expose the unit to rain
CAUTION! The following
states how damage to the ap-
pliance and possible injury to
people can be avoided:
• Ensure that the machine is cor-
rectly assembled and the filters
are in the correct position.
• Do not use without the filter. This
could damage the machine.
• Only use replacement parts
and accessories delivered and
recommended by our Service
Centre. The use of parts by other
manufacturers immediately ren-
ders the guarantee void.
• Only have repairs carried out
at our authorised customer ser-
vice points.
• Observe the instructions for
cleaning and maintenance of
the machine.
• Store the appliance in a dry
place and out of reach of chil-
dren.

Assembly

Pull out the mains plug.
Danger of electric shock.
1. Attach the castors (8) with ac-
cessory holders (8a) to the
underside of the container (6).
Fasten them with the enclosed
Phillips screws (8b).
2. Place the motor housing (3) on
top of the container (6) and
close it with the clips (5).
3. Lightly squeeze together the
ends of the retaining bracket
(29) and click it into the motor
housing (3).
GB MT
37