Assembly - Parkside PWD 30 A1 Originalbetriebsanleitung

• Switch the machine off and dis-
connect the mains plug:
- when the machine is not in use,
- before the machine is opened
up,
- for all maintenance and clean-
ing work,
- if the connecting cable is dam-
aged or tangled up.
• Never use the mains lead to pull
the plug out of the socket or to pull
the appliance. Protect the cable
from heat, oil, and sharp edges.
• Make sure that the mains volt-
age corresponds with the infor-
mation on the rating plate.
• Only plug the appliance into a
socket which is safeguarded.
• The device must only be con-
nected to a mains socket via a
residual-current circuit breaker
(RCD) with a rated leakage cur-
rent of not more than 30 mA.
• Do not expose the unit to rain
CAUTION! The following
states how damage to the ap-
pliance and possible injury to
people can be avoided:
• Ensure that the machine is cor-
rectly assembled and the filters
are in the correct position.
• Do not use without the filter. This
could damage the machine.
• Only use replacement parts
and accessories delivered and
recommended by our Service
Centre. The use of parts by other
manufacturers immediately ren-
ders the guarantee void.
• Only have repairs carried out
at our authorised customer ser-
vice points.
GB
• Observe the instructions for
cleaning and maintenance of
the machine.
• Store the appliance in a dry place
and out of reach of children.

Assembly

Pull out the mains plug.
Danger of electric shock.
1. Attach the castors (8) with accessory
holders (8a) to the underside of the
container (6).
2. Press the castor (8) towards the con-
tainer (6) so that the castors click into
place.
3. Place the motor housing (2) on top of
the container (6) and close it with the
clips (5).
The motor head (2) can only be placed
in one position on the canister (6).
The air flow control (3) and the device
socket (11) must be above the suction
connection (10).
4. Lightly squeeze together the ends of the
retaining bracket (28) and click it into
the motor housing (2).
5. Installing the accessories:
- Push the vacuum hose (20) into the
suction connection (10) until it locks
in place.
To remove it, press the catch (20a)
and pull the vacuum hose (20).
- Fit the handle with air control (17).
- Install the telescopic suction tube
(18). (Press the button on the tel-
escopic suction pipe towards
pull out to the desired length).
- Install the nozzle desired (
N ever vacuum without a filter!
Accessories such as the crevice noz-
zle (
25), upholstery nozzle
IE NI CY
and
23-27).
9