Operation; Switching On/Off; Airflow Control; Work Breaks - Parkside PWD 30 A1 Originalbetriebsanleitung

GB IE NI
( 26) or car nozzle (
be attached directly onto the han-
dle with air regulation (17).

Operation

Fully unwind the suction hose
(
20) before commencing work.

Switching on/off

Connect the mains plug.
To vacuum dust, plug the electrical
tool onto the mains socket on the
vacuum (
Only connect electrical appliances with a
maximum power rating of 1400 W.
Switching on the vacuum cleaner
(Permanent operation):
Move the On/Off switch (
position.
Switch on electrical appliance +
vacuum cleaner:
1. Move the On/Off switch
(
13) to the position
2. Switch on electrical appliance.
Switching on the electrical appli-
ance automatically switches on the
vacuum cleaner. Once the electrical
appliance has been switched off,
the vacuum cleaner switches off fol-
lowing a time lapse.
Switching off the vacuum cleaner:
Move the On/Off switch (
"0" position.
10
CY
27) can
11).
13) to the "I"
13) to the

Airflow Control

The airflow can be continuously adjusted
by turning the airflow controller (
minimum airflow
MIN:
maximum airflow
MAX:
When vacuuming with low-
powered electrical tools (such as
grinders or jigsaws), open the air
regulator on the handle (17). This
increases the suction power. To do
this, push the ring of the air regula-
tor upwards to three possible levels.

Work breaks

If you want to store away the assembled
suction equipment when you take a break,
you can
push the telescopic suction tube (18)

together and insert the suction tube
holder (19) into the accessory holder
(2a) on the motor head (2);
the telescopic suction tube (18) can be
‚
placed in the retaining bracket (28).

Dry vacuuming

The appliance is supplied with the
fluted filter (14) fitted.
Ensure that the folded filter (14) is
dry.
Vacuuming with a fluted filter:
1. To vacuum dry, fit the fluted filter (14)
onto the filter basket (3b) on the motor
housing (3). Here, the upward curved
sealing lip must point away from the
motor housing.
3).