Preventing And Clearing Paper Jams; Preventing Paper Jams; Removing Paper Jam - Mettler Toledo xpress XTC Bedienungsanleitung

7. Preventing and Clearing Paper Jams

7-1. Preventing Paper Jams

The paper should not be touched during ejection and before it is cut.
Pressing or pulling the paper during ejection may cause a paper jam, paper cutting
failure or line feed failure.

7-2. Removing Paper Jam

If a paper jam occurs, clear it as described below.
(1) Set the power switch to off to turn off power to the printer.
(2) Pull the lever toward you to open the printer cover.
If the printer cover will not open on auto cutter models, it means that the auto
cutter is not at the home position. In this case, return the auto cutter to the home
position by following the instructions provided in section 7-3. Then open the
printer cover after the paper jam has been removed.
(3) Remove the jammed paper.
Note: Take care not to damage the printer when removing the jammed paper.
Since it is easy to damage the thermal head in particular, take care not
to touch it.
(4) Position the roll paper straight and close the printer cover gently.
Note 1: Make sure that the paper is positioned straight. If the printer cover
is closed with the paper skewed, a paper jam may result.
Note 2: Lock the printer cover by pressing down on the sides. Do not try to
close it by pressing down on the center. The cover may not lock
properly.
(5) Set the power switch to on to turn on power to the printer. Make sure that the
ERROR LED is not lit.
Note: While the ERROR LED is lit, the printer will not accept any commands
such as the print command, so make sure that the printer cover is locked
properly.
– 19 –