Mettler Toledo xpress XTC Bedienungsanleitung Seite 20

20
F4 Sample Block
F5 Data Block
F6 Serial Interface
F3.3 Auto Clear Tare
Off =Disable auto clear tare
On = Enable auto clear tare
Automatic clear of tare occurs when net weight exceeds 9d. It settles to no
motion and then returns to within +/-3d from gross zero.
F4.1 Minimum Sample
Off = No minimum sample weight is required. The APW will "flash", if the
sample weight is below 0.05% of the capacity until the weight used to
calculate the new APW due to APW enhancement goes above 0.05%.
0.05 = Minimum sample is 0.05% of capacity. If the sample weight is below
this minimum sample weight, the count display will show "add XX" to require
additional samples and data display will blank out to indicate APW
calculation is forbidden until the sample weight is more than 0.05% of
capacity and the new APW is calculated.
0.10 = Minimum sample is 0.10% of the capacity.
0.20 = Minimum sample is 0.20% of the capacity.
F4.2 Average Piece Weight (APW) Enhancement
Off = Disable APW enhancement
On = Enable APW enhancement
F4.3 Auto Clear APW
Off = Disable automatic clear of APW
On = Enable automatic clear of APW
Automatic clear of APW occurs when gross weight (or net weight if a tare has
been taken) exceeds 9d, settles to no motion, and then returns to within +/-
3d from gross zero.
F5.1 Accumulation
Off = Disable accumulation
On = Enable accumulation
F5.2 Clear Accumulator after Print
Off = Disable clear after print
On = Enable clear after print
F5.3 Target Alarm
Off = Disable target alarm
On = Enable target alarm
F5.4 Alarm Mode
Off = Scale beeps continuously when count is within the target range
On = Scale beeps continuously when count is out of target range
F5.5 Alarm Type
Off = Weight alarm
On = Quantity alarm
F6.1 Baud Rate
STANDARD COUNTING SCALE