Christie LW41 Bedienungsanleitung Seite 22

STACK menu settings
3.3 Selecting lamp operation mode
NOTE •
When DUAL is selected for LAMP MODE, the images projected from
the Main and Sub projectors may be different. It is recommended to set the
projectors as follows.
- Set the same image for TEMPLATE and START UP on the Main and Sub
projectors.
- Capture the same image for MyScreen on the Main and Sub projectors.
- Save the same image on MY IMAGE on the Main and Sub projectors.
- Set the same message content for the Messenger
→ Messenger
• When DUAL is selected for LAMP MODE, image shift can result in image
quality degradation on the screen. Perform the MIRROR setting before
adjusting the image position as the image position will change when the
MIRROR setting is
• When ALTERNATE is selected and an error occur on the projector in
operation causing the lamp to turn off, the other projector will automatically start
to operate. However, if the RS-232C cable is disconnected or AC power is not
supplied, the other projector will not turn on.
• In cases when PIN LOCK or TRANSITION DETECTOR on both projectors
is set to ON (Operating Guide
not turn on even if ALTERNATE is selected. Enter the security code on both
projectors and one of the projectors will turn on.
• When Intellectual Stack is in use, the POWER indicator on the control panel
of the projector operates
Troubleshooting)
Main projector determines which projector to turn on according to the STACK
MODE setting if the STANDBY/ON button on the remote control or control
panel of the Main projector is pressed.
- The POWER indicator on the Main projector blinks in green while the Main
projector determines which projector to turn on.
- If the Main projector is turned on, the POWER indicator on the Main projector
turns to steady green after lighting up, as per normal.
- If the Sub projector is turned on, the POWER indicator on the Main projector
lights in orange after the Sub projector is turned on.
- If an error occurs on the Main projector, the Sub projector turns on and the
POWER indicator on the Main projector
LX41/LW41 User Manual - Instant Stack Guide
(continued)
Function) on the Main and Sub projectors.
changed. (Operating Guide
→
differently than normal.
When the Main and Sub projectors are in standby mode, the
function
→
SECURITY menu), the two projectors will
(Operating Guide
lights or blinks in red.
20
(Network Guide
SETUP menu)
→
020-000509-01 Rev.1 (06-2012)