Agilent Technologies 4UHV Gebrauchsanleitung Seite 105

Diagnostic Buffer (15 byte)
Tab. 25
Offset Meaning
0 B station non exist (set by master)
0
B station not ready (slave not ready for data exchange)
1
B cfg fault (configuration data doesn't match)
2
B ext diag (slave has external diagnostic data)
3
B not supported (slave doesn't support requested function)
4
B invalid slave response ( slave sets permanent '0')
5
B prm fault (wrong parameter assignment)
6
B master_lock (slave is parameterised by another master)
7
1 B prm req (slave has to be re-parameterised)
0
B stat diag (static diagnosis)
1
B fixed '1'
2
B wd_on (response monitoring active)
3
B Freeze mode (received freeze command)
4
B Synch mode (received synch command)
5
B reserved
6
B diag deactivated (slave is parameterised by another master)
7
2 Reserved
3 Master Add (master address after parameterisation. FF= without parameter)
Ident number high
4
5 Ident number low
6 External diagnosis "Header" length indication including header
Agilent 4UHV Ion Pump Controller User Manual
Technical Information
/ 87-900-137-01 (D)
5
PROFIBUS
105/114