Megasat HD 935 Twin V2 Bedienungsanleitung Seite 51

4. Main Menu
Signal Detection
The menu item „Signal Detection" is only active if you have selected Tuner mode 1/2.
Then you can set different tunes for Tuner 1 or Tuner 2
(e.g. Tuner 1 = Universal LNB, Tuner 2 = Unicable).
LNB Typ
Here you need to check the LNB typ according to your antenna, set the correct fre-
quency or define yourself. The default setting (Universal) is true in most cases.
Unicable System:
In the menu item LNB Type, you can make the settings for single-cable systems (Unicable,
Unicable 2, SCD2, JESS). The set-top box is programmable for different Unicable systems.
Depending on the system, up to 32 set-top box can be connected.
Unicable A/B/C (EN 50494)
This setting is suitable for Unicable systems with up to 8 users. IF programs allow you
to select up to 8 different programs, each IF program being assigned a frequency.
Select the desired IF program (1-8). Then select the main frequency and confirm with
OK. Now enter the frequency according to your Unicable system.
SCD2 A/B/C/D/E/F/G/H (EN 50607)
This setting is suitable for Unicable 2 (JESS) systems with up to 32 users. IF programs
allow you to select up to 32 programs, each IF program being assigned a frequency.
Select the desired IF program (1-32). Then select the main frequency and confirm
with OK. Now enter the frequency according to your Unicable system.
Use the SCD2 A/B/C/D/E/F/G/H option to control up to 8 satellites.
Note: Basically, one uses the lowest frequency for the longest cable path to the set-
top box. Note that each frequency may only be present once in your system. The fre-
quencies depend on your single-cable system and can not be allocated as desired. IF
program and IF frequency must compulsorily match your Unicable system.
LNB Power
Here you need to check the LNB power according to your antenna, set the correct
frequency or define yourself. The default setting (13V/18V) is true in most cases.
22KHz
In case you are using two antennas connected to a 22KHz tone switch box. You can
supply either 22KHz by setting "OFF" to select antenna.
ENGLISH
11