Installation And Setting; Operation - Meister KB135M Originalbetriebsanleitung

• The maximum recommended
diameter of mounted wheels,
threaded cones and plugs shall not
exceed 55 mm and that the maximum
recommended diameter of sanding
accessories shall not exceed 80 mm
ATTENTION! The insertable
tools continue to run after the
machine is switched of. Wait until the
machine has come to a dead stop
before putting it down.
• To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
Safety marking
The symbols on the housing mean the
following:
Important! Observe the
operating instructions!
Do not dispose of with
domestic waste!
Voluntary "geprüfte Sicherheit"
seal of quality (tested safety)
The housing is double
insulated
Electronic rotation speed
regulation
CE mark (conformity with
European safety standards)
IMPORTANT! Wear goggles.
IMPORTANT! Wear ear
defenders.
MW-5400620-Bedien-1811.indd 55
IMPORTANT! Wear a dust
protection mask.
7 – Installation and setting
Inserting tools (Fig. 3)
ATTENTION! Switch of the
machine, turn the speed control
to the lowest setting and pull out the
power plug!
Press and hold down spindle lock (7),
screw off the tensioning screw of the
tool holder (6). Insert a collet chuck (8)
which fits the tool into the tool holder,
position the tensioning screw and turn it
loosely into position. Insert the tool and
tighten the tensioning screw with the
universal wrench (9).
– The maximum protrusion of the tool
is 23 mm
– The maximum mandrel length is
45 mm
ATTENTION! Ensure that the grip
guard (5) is always in position
when working!
8 – Operation
Start­up Operation
CAUTION! The appliance may be
operated only in a dry, well­lit
environment.
To prevent the tool from starting
accidentally, ensure that the ON/OFF
switch is in the OFF (position O) and
the speed-control knob (2) is set to
the lowest setting (stop „–") before
connecting the power plug to a socket.
55
24.04.19 12:27