Assembly And Installation - Yamaha YZ250F Fahrer- Und Wartungshandbuch

1
Å
CRANKCASE AND CRANKSHAFT
a
b
ı
EC4N5000

ASSEMBLY AND INSTALLATION

Crankcase bearing
1. Install:
Bearing
G
Bearing stopper
G
Bolt (bearing stopper)
G
Screw (bearing stopper)
G
Screw [bearing stopper (crankshaft)] 1
G
To left and right crankcase.
NOTE:
Install the bearing by pressing its outer race
G
parallel.
To prevent the screw [bearing stopper
G
(crankshaft)] from becoming loose, crush the
screw head periphery a into the concave b
using a punch etc. In so doing, take care not
to damage the screwdriver receiving hole in
the screw head.
Crankshaft
1. Install:
Crankshaft 1
G
Use the crankshaft installing tool 2, 3,
4 and 5.
Crankshaft installing pot 2:
YU-90050/90890-01274
Crankshaft installing bolt 3:
YU-90050/90890-01275
Adapter (M12) 4:
YU-90063/90890-01278
Spacer (crankshaft installer) 5:
YU-91044/90890-04081
Å For USA and CDN
ı Except for USA and CDN
NOTE:
Hold the connecting rod at top dead center
G
with one hand while turning the nut of the
installing tool with the other. Operate the
installing tool until the crankshaft bottoms
against the bearing.
Before installing the crankshaft, clean the
G
contacting surface of crankcase.
CAUTION:
Do not use a hammer to drive in the crank-
shaft.
4 - 93
ENG
10 Nm (1.0 m · kg, 7.2 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)