Yamaha YZ250F Fahrer- Und Wartungshandbuch Seite 524

FRONT FORK
21. Measure:
Distance a
G
Out of specification → Turn into the
locknut.
Distance a:
19 mm (0.75 in) or more
Between damper rod 1 top and
locknut 2 top.
22. Loosen:
Rebound damping adjuster 1
G
NOTE:
Loosen the rebound damping adjuster finger
G
tight.
Record the set position of the adjuster (the
G
amount of turning out the fully turned in posi-
tion).
23. Install:
Push rod 1
G
Fork spring 2
G
NOTE:
Install the fork spring with the damper rod 3
G
pulled up.
After installing the fork spring, hold the
G
damper rod end so that it will not go down.
24. Install:
Spring seat 1
G
Front fork cap bolt 2
G
NOTE:
Fully finger tighten the front fork cap bolt onto
the damper rod.
25. Tighten:
Front fork cap bolt (locknut) 1
G
NOTE:
Hold the locknut 2 and tighten the front fork
cap bolt with specified torque.
5 - 36
CHAS
29 Nm (2.9 m · kg, 21 ft · lb)