Torqeedo Travel 503 Originalbetriebsanleitung Seite 94

DE EN
Display
E21
E22
E23
E30
E32
page 94 / 112
Cause
Incorrect calibration of tiller
Magnetic sensor defective
Value range incorrect
Communication error with motor
Tiller communication error
What to do
Recalibrate:
1. Press and hold the CAL button for ten seconds.
cal up appears on the display.
2. Set the tiller to full throttle forwards.
3. Press the CAL button.
cal stp appears on the display.
4. Set the tiller to the neutral position.
5. Press the CAL button.
cal dn appears on the display.
6. Set the tiller to full throttle reverse.
7. Press the CAL button.
Recalibrate, see "E21". If the error code appears several times, then con-
tact Torqeedo Service.
Recalibrate, see "E21".
Check the cables and the plug connections of the data cables.
Clean the contacts using contact spray.
If necessary, contact Torqeedo Service and tell them the error code.
Check the plug connections on the tiller.
Clean the contacts using contact spray.
Check the cable.
Error messages