Important Information; Ce Marking; Warnings; General Safety Warnings - EKOM DK50 Gebrauchsanweisung Und Servicehandbuch

DK50
DK50 PLUS

IMPORTANT INFORMATION

1. CE MARKING

Products labeled with compliance mark CE meet safety Guidelines of the European Union. (98/37/EEC -
Council Directive of Safety of Machinery, 73/23/EEC – Low-voltage directive).

2. WARNINGS

2.1. General warnings
 This Instructions for use is a part of the appliance and must be kept with the compressor. Careful review
of this manual will provide the information necessary for correct operation of the appliance.
 The safety of operating personnel and trouble-free operation of the appliance are guaranteed only if
original parts are used. Only accessories and parts mentioned in the technical documentation or expressly
approved by the manufacturer can be used.
 If any other accessories or consumable materials are used, the manufacturer cannot be held responsible
for the safe operation of the appliance. This guarantee does not cover damages originating from the use
of accessories or consumable material other than those specified or suggested by the manufacturer.
 The manufacturer guarantees the safety, reliability and function of the appliance only if:
- Installation, new settings, amendments, extensions and repairs are performed by the manufacturer or
its representative, or a service provider authorized by the manufacturer
- The appliance is used in accordance with this Instructions for use
 The manufacturer reserves all rights for the protection of its wiring diagrams, methods and names.
 Translation of Manual for Installation, Operation and Maintenance is carried out in accordance with the
best knowledge. In the case of ambiguities, the Slovak version of the text prevails.
2.2.

General safety warnings

The manufacturer developed and designed the equipment in such a way so that any risks were excluded if it
is used according to intention. The manufacturer considers it to be its obligation to describe the following
safety measures in order to exclude residual damages.
 Operation of the appliance must be in compliance with all local codes and regulations.
 Original packaging should be kept for the return of the appliance. Only the original packaging ensures
protection of the appliance during transport. If it is necessary to return the appliance during the guarantee
period, the manufacturer is not liable for damages caused by improper packaging.
 Each time the appliance is used, the operator must make sure that it is functioning correctly and safely.
 The user must fully understand the operation of the appliance.
 The product is not intended for operation in areas with a risk of explosion.
 If any problem occurs during use of the appliance, the user must inform his supplier immediately.
2.3.

Electrical system safety warnings

 The appliance must be connected to earth (grounded).
 Before the appliance is plugged in, make sure that the mains voltage and mains frequency stated on the
appliance are the same as the power mains.
 Prior to putting into operation it is necessary to check for possible damage of the equipment and
connected air and electric distributions. Damaged pneumatic and electric lines must be immediately
replaced.
 Immediately disconnect the appliance from the mains (pull out mains plug) if a technical failure occurs.
 During repairs and maintenance, ensure that:
- The mains plug is pulled out from the socket
- Pressure pipes are vented and pressure is released from the air tank.
 The appliance must be installed by an approved, qualified technician.
10/2015 - 5 - NP-DK50-7_10-2015-A-MD